It is a rod with an orange-colored rubber-like coating near the battery box that you can pull out.Īfter you pull out the transmission fluid dipstick, you will see four marks near the bottom. The Mazda 3 has a transmission dipstick that you can use to check the transmission fluid level. But how do you know if your engine is low on transmission fluid? Your Mazda 3’s onboard computer will ignite the AT light once it senses that the transmission fluid is at a low level. We will be focusing on the transmission problems in this article. They could be pointing to the same problem or to two separate problems that are related. There are times when the AT light will trigger along with the check engine light. The AT light is triggered by Mazda 3’s onboard computer once a sensor detects a possible problem with the transmission system. This includes the components that allow your car to run, and the transmission system is a good example. Your Mazda 3 is built with many sensors that detect issues that could affect the health of your engine. It is usually composed of the transmission, the axles (this is why it is sometimes called the transaxle), and the differential. The AT or your automatic transaxle is responsible for changing gears without the need for any input from you. Knowing where the problem could be coming from is the first step to fixing it. Let’s talk about the “AT” on that warning light. Fixing what triggered the AT light in the first place is the true resolution to the AT light issue. The transmission system is one of the more expensive systems to replace and repair. Thus, if you see the lit-up AT light on your dashboard, it is trying to alert you to a possible problem with a component of the transmission system. The “AT” on that light stands for the automatic transaxle, which refers to the transmission system of your Mazda 3. So, what are these underlying causes that could have triggered the AT light? Read all about them in the succeeding sections, including the symptoms for each one. There is a high possibility that the AT light will keep coming back unless the underlying cause is addressed. These steps will only reset the AT light, which is a notification that there is something wrong-you’re getting rid of the notification without addressing the problem that triggered it. Keep in mind, however, that this is not a real fix. Turn off the ignition, then turn it back on again all the way to turn on the engine.Step on the gas pedal all the way to the floor and hold it there for 30 seconds.Turn on the ignition without turning on the engine.Did you have difficulty starting up your Mazda 3 one morning and heard a clanking noise? Or maybe you were driving when your Mazda 3 slightly jerked like it was having a hard time shifting gears? You can stop puzzling over the issue because we can answer the question for you here.įollow the steps below to fix or reset the AT light on your Mazda 3:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |